Mannings 65kVA Power Unit With 6 Temperature Controllers

    •  These units provide a 65V supply for powering various types of low voltage heating elements. The output channels are controlled by means of energy regulators and temperature controllers,

     

      provision is also made for external control from any suitable programmer via a panel mounted control plug. Each channel has its own auto/manual switch so any combination of channels can be operated in either auto or manual mode. The units are protected against over current or over temperature conditions.

     


    STORK
Cooper36 Channel Unit

    •  

     Stork Cooperheat’s Cooper36 has been specifically designed to heat treat up to 36 small tubes and pipes simultaneously. With Stork Cooperheat’s extensive industry knowledge, it was recognised that there was a requirement for a unit with a higher number of control channels that would be capable of controlling one heater per output specifically designed for small tubes / pipes (i.e. 1” to 5” diameter welds). Traditionally, these pipes are heat treated using multiple standard (6 channel) heat treatment units which results in tying up 300kW of machine output power. However, with the development of Cooper36, one machine with 36 control channels can treat up to 36 pipes at one time using 50kW output power for 36 small diameter pipe welds.


    STORK
Cooper-K9

    •  

    The Cooper-K9 splits into two halves. The top half contains the six point recorder and three programmer/controllers and contactors. The lower half contains the power transformer and air circulation fan. The compact module not only avoids the use of heavy lifting equipment, in addition it avoids mobilising valuable 50kVA or 70kVA assets to smaller heat treatment work scopes which may require less than 10kVA of power.


    STORK
The 3-Phase Control Trolley

    •  The 3-phase control trolley, when used in combination with

    4-Bank Channel Elements, is an ideal mobile unit for providing
    power, switching and temperature control for internal vessel
    heat treatments and temporary furnaces.
    Six circuits of three elements can be controlled (connected
    in star) to the 3-phase control trolley providing a maximum
    power output from eighteen 4-bank channel elements of
    238kW from a 415V supply and 218kW from a 380V supply.
    Each of the six power and control channels are protected by
    three, 60A, miniature circuit breakers and controlled by an
    Advantage 3 temperature programmer/controller.

    STORK
70 KVA Heat Treatment Module

    •  Compliance with international heat treatment codes and standards

    requires equipment that can provide accurate control of the heat
    treatment specification parameters, including uniformity of temperature
    throughout the geometry of the work piece. As part of our commitment
    to continuing innovation, Stork Cooperheat’s 70kVA Heat
    Treatment Modules

    HTM
50 KVA Heat treatment Module

    •  Compliance with international heat treatment codes and standards

    requires equipment that can provide accurate control of the heat
    treatment specification parameters, including uniformity of temperature
    throughout the geometry of the work piece. As part of our commitment
    to continuing innovation, Stork Cooperheat’s 50kVA

    HTM

1